Wednesday, May 18, 2011

Power control In WCDMA

  • Open Loop
  • Inner Loop
  • Outer Loop
Open Loop Power control-The Open loop power control technique requires that the transmitting entity measures the channel interference and adjusts its transmission power accordingly. This can be done quickly, but the problem is that the  interference estimation is done on the received signal, and the transmitted signal probably uses a different frequency, which differs from the received frequency by the system’s duplex offset. As uplink and downlink fast fading (on different frequency carriers) do not correlate, this method gives the right power values only on average.
Inner Loop-In this method the received signal-to interference ratio (SIR) is measured over a 667- microsecond period (i.e., one time slot), and based on that value, a decision is made about whether to increase or decrease the transmission power in the other end of the connection. Note that the delay inherent in this closed-loop method is compensated for by making the measurements over a very short period of time. The transmit power control (TPC) bits are sent in every time slot within the uplink and the downlink.
There is not a neutral signal; all power control signals contain either an increase or decrease command.
Outer Loop-The outer loop power control functions within the base station system, and adjusts the required SIR value (SIRtarget), which is then used in the inner loop control. Different channel types, which can be characterized by, for example, different coding and interleaving methods, constitute a channel’s parameters. Different channel parameters may require different SIRtarget values. The final result of the transmission process can only be known after the decoding process, and the resulting quality parameter is then used to adjust the required SIR value. If the used SIR value still gives a low quality bit stream, then the outer loop power control must increase the SIRtarget value. This change in the outer loop will trigger the inner loop power control to increase the mobile station transmission power accordingly.


Download UMTS Call Flow

No comments:

Post a Comment