RSRP and RSRQ

In cellular networks, when a mobile moves from cell to cell and performs cell selection/reselection and handover, it has to measure the signal strength/quality of the neighbor cells. In LTE network, a UE measures two parameters on reference signal: RSRP (Reference Signal Received Power) and RSRQ (Reference Signal Received Quality).

RSRP is a RSSI type of measurement. It measures the average received power over the resource elements that carry cell-specific reference signals within certain frequency bandwidth. RSRP is applicable in both RRC_idle and RRC_connected modes, while RSRQ is only applicable in RRC_connected mode. In the procedure of cell selection and cell reselection in idle mode, RSRP is used.

RSRQ is a C/I type of measurement and it indicates the quality of the received reference signal. It is defined as (N*RSRP)/(E-UTRA Carrier RSSI), where N makes sure the nominator and denominator are measured over the same frequency bandwidth.

The carrier RSSI (Receive Strength Signal Indicator) measures the average total received power observed only in OFDM symbols containing reference symbols for antenna port 0 (i.e., OFDM symbol 0 & 4 in a slot) in the measurement bandwidth over N resource blocks. The total received power of the carrier RSSI includes the power from co-channel serving & non-serving cells, adjacent channel interference, thermal noise, etc.

The RSRQ measurement provides additional information when RSRP is not sufficient to make a reliable handover or cell reselection decision. In the procedure of handover, the LTE specification provides the flexibility of using RSRP, RSRQ, or both.